SoundImpress HY502-4CH Quad Amplifier|500WPC|Ncore® by Hypex
SoundImpress HY502-4CH Quad Amplifier | 500WPC | Ncore® | Powered by Hypex
This SoundImpress amplifier is a self-contained high-end class-D four channel amplifier intended for a wide range of audio applications, ranging from public address systems to ultra high-fidelity replay systems for studio and home use.
SoundImpress HY502-4CH Quad Amplifier | 500WPC | Ncore® | Powered by Hypex
.
Highlights
- Ncore® technology inside
- Impressive performance despite load
- Neutral and transparent reproduction
- Flat, fully load-independent frequency response
- Plenty of power combined with high efficiency
- Compact design
- XLR inputs, binding posts output
- Assembled by hand in the Netherlands
- 5 year Warranty
-
Product details
Small and powerful
This amplifier can deliver all its power from as low as 2 ohm impedance combined with low idle loss, very low distortion and noise levels. Chief distinguishing features are flat frequency response irrespective of load impedance, nearly frequency independent distortion behaviour and very low radiated and conducted EMI. This results in performances such as the max output power of 500 Wrms at 4 ohm per channel, a Signal-to-Noise Ratio (SNR) of 124 dB and astonishing distorting level of 0.0018%.
An amplifier is only as good as the power supply it contains. In this SoundImpress amplifier, the power supply and amplifier are located on one board. The switched-mode power supply (SMPS) providing the power for the amplifier is a compact, high power, highly efficient, regulated half bridge converter with synchronous rectification on the main output rails. These properties make this technology ideal for powering class-D audio amplifiers.
Specifications
- Article number HY502-4CH
- Rated power output (RMS) 4 x 500 watts at 4 ohms 4 x 350 watts at 8 ohms
- Minimum load 4 ohm
- Signal-to-noise ratio (SNR) 124 dB
- Distortion 0.0018% THD+N (20-20,000 Hz at 0.5 x rated power output)
- Efficiency 92%
- Frequency response 10 - 48,000 Hz
- Circuit Topology Ncore®
- Amplifier classification Class D
- Speaker output channels 4
- XLR in/out 4/0
- Banana plug compatible Check
- Power requirements 110 / 230 VAC
- Power inlet connector IEC C14
- Dimensions (D x W x H) 326mm x 300mm x 100mm (size incl feet, excl connectors)
- Case material Aluminum
-
What’s In The Box
- SoundImpress HY502-4CH Quad Amplifier
- IEC C13 power cable (UK/EU/US)
- SoundImpress manual
Products from the same category
Products from the same brand