HiVi F10 10" Woofer 8 ohm

The HiVi F10's design has been optimized for dynamic low bass performance in a compact or medium size vented enclosure.

.

Highlights

• Light and extremely rigid cone made from Kevlar/paper composite
• High loss rubber surround
• High power handling polyimide former voice coil
• Long-throw motor system with extended linear excursion capability
• High-density aluminum die-cast basket

.

Product details

HiVi F10 10" Woofer

The HiVi F10's design has been optimized for dynamic low bass performance in a compact or medium size vented enclosure. The F10 utilizes a newly developed matrix of Kevlar and paper fibers. The cone weighs less, is more rigid, and has an improved damping factor. It keeps distortion very low through the woofer's wide frequency and power range. The driver has a vented pole piece to avoid air compression and ensure maximum power handling. The long-throw design provides clean and articulate bass performance at high volumes. A massive aluminum die-cast basket has been developed to minimize structural resonances. Recommended crossover frequency, 300Hz.

.

Specifications

• Article number F10
• Woofer Type Midwoofer
• Nominal Diameter 10"
• Power Handling (RMS) 100 Watts
• Power Handling (max) 200 Watts
• Impedance (Z) 8 ohms
• Sensitivity (SPL at 1m / 2.83V) 89 dB
• Frequency Response 28 to 3,000 Hz
• Voice Coil Diameter 2"
• DC Resistance (Re) 6.5 ohms
• Resonant Frequency (Fs) 28 Hz
• Mechanical Q (Qms) 5.12
• Electromagnetic Q (Qes) 0.33
• Total Q (Qts) 0.31
• Diaphragm Mass Inc. Airload (Mms) 72.6g
• Mechanical Compliance of Suspension (Cms) 0.42 mm/N
• Surface Area of Cone (Sd) 363 cm²
• BL Product (BL) 16.2 Tm
• Compliance Equivalent Volume (Vas) 2.78 ft.³
• Maximum Linear Excursion (Xmax) 6 mm
• Cone / Diaphragm Material Paper / Kevlar
• Surround Material Rubber
• Voice Coil Former Kapton® / Polyimide
• Dual Voice Coil No Basket / Frame
• Material Cast Aluminum
• Magnet Material Ferrite S
• hielded Yes
• Overall Outside Diameter 11.26"
• Overall Depth 4.41"
• Baffle Cutout Diameter 9.29"
• Mounting Holes 12
• Sealed Volume 0.43 ft.³
• Sealed F3 77 Hz
• Vented Volume 0.99 ft.³
• Vented F3 48 Hz