Helix DSP PRO MK2 10-channel PROCESSOR



Digital 10-channel audio processor DSP HX PRO MK2

More details

2 Items


Warning: Last items in stock!

679,00 €

799,00 €

-120,00 €

Add to wishlist

By buying this product you can collect up to 67 loyalty points. Your cart will total 67 loyalty points that can be converted into a voucher of 13,40 €.

More info

The signal processor for those who are only satisfied with the best! The new HELIX DSP PRO MKII sets not only in terms of
sound quality raises the bar to a new level. By using the most efficient audio DSP of the latest generation with
enormous 64-bit resolution, this device provides more computing power than all signal processors currently available on the market. For this he is
the first of its kind, which performs the complete signal processing with a sampling rate of 96 kHz and thus an expanded
allows audio frequency response up to 40 kHz!

Digital high-end 10-channel signal processor with 96 kHz sampling rate

• "stand-alone" high-end 64-bit 295 MHz 10-channel DSP
• HiRes audio sound quality due to full audio bandwidth (> 40 kHz)
• Inputs:
  8 x RCA (2-4 volts, 2 channels internally repositioned
  on increased sensitivity be 250 - 500 mV)
  8 x high level (5-10 volt or 10-20 volts) and "ADEP" circuit *
  1 x coaxial SPDIF • 1 x Optical SPDIF • 1 x remote
• output:
  . 10 x RCA (max 8 volts) • 1 x remote Out
• all-pass filter
• HELIX extension Card slot (HEC) for additional input / output modules, such as
• Bluetooth® audio streaming • AUX iN • Optical iN
• input delay compensation to 5ms per channel
• Delay of high-precision 3.5 mm steps
• signal - / noise ratio: Digital 116 dB / analog 108 dB (A)
• drag-drop signal routing with separate matrices
• filter types with higher slope between 6 - 42 dB selectable
• Powerful "Fixed Point" Audio DSP 64-bit resolution
• 30-band EQ per channel in precise 0.25 dB steps adjustable
• fine adjustment of the respective bands in 1/24 octave steps and quality setting of between 0.5 and 15

96 kHz sampling rate

The DSP PRO MK2 provides a signal processing with a double sampling rate of 96 kHz. Thus, the audio bandwidth is not as usual, limited to 22 kHz, but also allows an extended frequency response up to 40 kHz. but the higher sampling rate is significantly higher demands on the DSP itself, because the number of possible arithmetic operations is reduced by half with a doubling of the sampling rate. Only the use of the latest generation of chips makes it possible to increase the sampling rate to 96 kHz despite further enhanced features and number of channels.

Power Save Mode

The Power Save mode is implemented by default. It allows to reduce the power consumption of the devices connected to the processor amplifier drastically when there is no input signal for longer than 60 sec.. It should be noted that today many vehicles with "CAN" or similar internal bus systems are equipped, the "invisible" on the radio for the user yet to 45min up. leave it on, even if one has since left the vehicle and closed. As soon as the "Power Save Mode" is active, the "Remote Output" and so that the connected amplifier is switched off. The DSP HELIX PRO MK2 reactivates the Remote Output within 1 second, once again a music signal at one of its inputs. It is also possible to vary the delay time on the PC tool software or disable the "Power Save Mode" completely.

Start / stop capability

The power supply in the DSP PRO MK2, the internal power supply even for short-term dips in the power supply down to 6 volts. This ensures that the HELIX DSP PRO remains fully functional even when the engine starts.

Automatic Digital Signal Detection

The switch between the analog and optical digital input signal is carried out controlled. Once an audio signal at the "Optical Input" is detected, the processor switches to this input. In the PC software tool, this function can be disabled or alternatively a manual control via the optional remote control URC2A be selected.

HELIX Extension Card

But that is not all - called the new HELIX Extension Card slot, or "HEC", this unit makes extremely flexible and versatile. It allows to expand using optional HEC modules DSP PRO MK2 to other features - for example, a Bluetooth audio streaming function, another optical digital input or an optical digital output.

DSP PC-Tool 3.0

Brand new and yet familiar is the completely revised DSP PC-Tool Software 3.0.Genauso intuitive as before, it enables numerous additional functions and a more precise adjustment of all parameters. The built-in software Real-Time Analyzer now has the revolutionary "AutoSet" function that makes the equalizer adjustment easy.

Also Bought Products