Audio Development AD4CX coaxial bi-wiring coaxial 10 cm

Audio Development AD4CX coaxial bi-wiring coaxial 10 cm

High quality 100mm bi-wiring coaxial consisting of W4 midwoofer + T19 tweeter

CONE: Fibreglass with rubber suspension. 

WOOFER VOICE COIL: Pure copper wire on aluminium former (26 mm diameter).

BASKET: PPO chassis injected with fibreglass, in order to low down undesired distortions.

TWEETER: Silk dome Ÿ” diameter, with neodimium magnet and Ferrofluid cooling.

The decision to offer a line of coaxials derived from the TREND line, could sound unusual, looking at the common conception of these products, seen often as synonymous of economic. We believe that quality could not be abandoned even in this choice, sometimes forced due to installation problems, sometimes chose to complete an existing front system of good quality. Whatever is the reason, the solutions for a high quality coaxial are restricted, and in these the TREND line of AD is one of them. Phase and impedance curves are measured after 20 hours burn-in at 20 W RMS, so are the T / S parameters.

Le: 0.46 mH

Re: 2.8 ohms

Fs: 85 Hz

Qms: 4.15

Qts: 0.64

Vas: 2.11 liters

Bl: 3.39

Frequency Range: 80-20000Hz

SD: 50 cm²

Xmax: 12mm

Pmax: 50W

dBSppl: 87dB

Technical Specifications

• Coaxial type
• Speaker Size 100 mm
• 2-way coaxial type
• Frequency response 80 - 20000 Hertz
• MAX Power Watt
• RMS power 50 Watts
• Sensitivity 87 dB
• Impedance 2.8 Ohm
• Woofer Fibreglass material
• Tweeter Silk dome material