Hypex UcD2k 1x2000W Universal Class D Amplifier Module
The UcD2k amplifier module is an entry level high-end class D amplifier from Hypex. The UcD2k is known for its high performance, reliability and ease of use. The UcD2k comes with the required UcD Signal Cable.
-
Highlights
Flat, fully load-independent frequency
Low output impedance
Very low, frequency-independent THD
Very low noise
.
Product details
Hypex UcD2k 1x2000W Universal Class D Amplifier Module
The UcD2k amplifier is intended for a wide range of audio applications, ranging from Public Address systems to ultrahigh-fidelity replay systems for studio and home use. Hypex distinguishes their amplifiers from other class D designs due a unique circuit topology. This results in flat frequency response irrespective of load impedance, nearly frequency-independent distortion behavior and very low radiated and conducted EMI.
The Hypex UcD modules have established themselves as the new standard, both in terms of measured and subjective performance and therefore very suitable as amplifier in professional audio as well in consumer purposes.
.
Features
Runs on unregulated +/- rails
POP-free start and stop control
Differential audio input
On-board clipping detection
DC-fault detection
Overcurrent and overvoltage protection
.
What’s In The Box?
UcD2k amplifier module
Mounting set UcD
UcD Signal Cable
Manual
The UcD amplifier module only needs the proper power supply to start with their efficient, ultra-clean power delivery. We recommend the SMPS3kA700 as power supply for the UcD2k amplifier module.
-
Specifications
Article number UcD2k
Rated power output
1x 2500 watts at 4 ohms
1x 1600 watts at 8 ohms
1x 2000 watts at 2 ohms
Minimum load 1 ohm
Efficiency 92 %
Signal-to-noise ratio (SNR)
Distortion 0.02 % (20-20,000 Hz @ 0.5 x Rated power output)
Frequency response. 10 - 50,000 Hz
Gain 34 dB
Input sensitivity 2.25 Vrms for rated power output
Input impedance 100k ohms
Amplifier Classification Class D
Circuit Topology UcD®
Speaker output channels 1
Input connection type
4 pin PCB connector
10 pin PCB connector (through from power supply)
Speaker output connection type :Crimp/solder connection tabs
DSP function
Bluetooth
EQ Adjustment
Power Requirements
50 - 98 VDC (symmetric supply +/-)
13 - 15 VDC (driver supply voltage)
Power inlet connector Crimp/solder connection tabs
Current limit 50 A
Under/over voltage protection
Dimensions (L x W x H) 141 x 108 x 38 mm
Products from the same category
Products from the same brand