AMB2050NR KIT2 - Class D 2x50W Bluetooth amplifier w+ power supply + volume
AMB2050NR KIT2 - Class D 2x50W Bluetooth amplifier with power supply and volume control
LUXUS AUDIO - AMB2050NR KIT2
The Board AMB2050TR is a Class D amplifier based on the TPA3116D2 chip with integrated bluetooth module and TWS on board system.
The output power of the class D amplifier is 50W with a supply voltage of 24V. The voltage range supported varies from a minimum of 10V to 24V. It drives passive loudspeakers that vary from a nominal impedance of 4 to 8 ohms.
The sources used, in order to send music signal to the Class D amplifier, can be connected via cable (RCA) or by means of Bluetooth 4.0 protocol, selectable via micro-switch located on the board.
AMB2050TR can automatically detect the Aux / Line input in the audio input. Bluetooth audio source has a higher priority. When Bluetooth audio is paused or bluetooth is disconnected. The amplifier will output Aux in / Line audio. If you want to manually select the Aux in / Line in and bluetooth audio source, select AMB2050TR.
TWS mode supported. Users can transmit audio to 2-pair amplification boards simultaneously wirelessly.
Multiple AMB2050TR cards can be connected together to become a multi-channel amplification system. The audio output port can also be connected with a subwoofer amplifier board. BVC port: the BVC port can connect with our audio volume controller to control the Bluetooth audio volume.
The highlight is supported by APT-X and TWS. Therefore, users can transmit audio to 2-pair amplification boards at the same time wirelessly. It is perfect for your Hi-Fi application. You may want to pair a cell phone or computer (etc.). Power the amplifier board. Use your phone or PC (etc.) to search for a new Bluetooth device. The form will appear as "AMB2050TR". You don't need a PIN, match it and then you can listen to music.
AMB2050TR can automatically detect the Aux / Line input in the audio input. Bluetooth audio source has a higher priority. When Bluetooth audio is paused or bluetooth is disconnected. The amplifier will output the TV sound.
AMB2050TR + AMB2050TR, Both RCA inputs and Bluetooth audio volume can be controlled via the BVC port.
Multiple AMB2050TR cards can be connected together to become a multi-channel amplification system. The audio output port can also be connected with a subwoofer amplifier board.
2 cards work in TWS mode
* The user must remove the Aux slave card in Enable jumper before associating 2 cards.
Download below the Procedure to Connect two APT-X Bluetooth Receivers in TWS mode.
Attention: the VCB0M01 volume control is supplied with 3 wires. For this kit, use
only the 5-pin cable to connect the volume control to the amplifier as shown above.
Features AMB2050NR
Others features AMB2050NR
Technical Features Volume Control VCB0M01
Power Supply Technical Features ALC24V6AJ
Products from the same category
Products from the same brand