Power Supply / Charger 60V/10A for LFP/LTO Cells

• Quality material: made of high quality plastic material, sturdy and durable, can be used for a long time.
• Widely compatible: suitable for a variety of electrical appliances, such as power supply, electronic products, electric equipment, etc.
• Easy and fast installation: it is easy to install and disassemble, which can save your time and energy. The installation is very convenient.
• Power supply: the power supply has a usb port, which can be used to charge your electronic devices and other devices.

-

Product features

Designed with 10-turn potentiometers for more precise values

Automatic conversion with constant voltage and constant current

Over voltage (OVP), over current (OCP), over temperature protection (OTP).

Circuit designed to be used for 24-hour full load working

Intelligent fan controlled by temperature

-

Technical specification

Voltage Input: AC 220V 50Hz

Voltage Output: DC 0-60V adjustable

Current Output: DC 0-10A adjustable

Resolution: voltage 0.1V, current 0.1A

Accuracy: +/-1%+/-1 digit

LED display: two displays with 4 digits

Settings: coarse and fine voltage and current

Wide operating temperature: -10 °C - +40 °C

-

TIP: Charging single cells using the regulated (laboratory) power supply

This laboratory power supply allow charging of the individual cells. Using such a regulated power supply is a suitable method for performing the initial charging or for the balancing of a single cell in a battery pack (by means of charging to a fixed voltage level).

There are usually 3 steps to follow:

1) set the target voltage (open voltage) – without the connection of the battery (3.65 V),

2) start charging and set the current to be used (3.0 A),

3) when the charger reaches the target voltage – it usually starts to reduce the charging current until a low value. (3.66 V reached at 0.04A). It is a time to stop charging and disconnecting the charger.